AIR COOLING EXAMPLES: Data Centre Cooling Factory Cooling Warehouse Cooling Industrial Cooling Office Cooling IT Room Cooling School Cooling
Evaporative Cooling Configuration
Whilst it is possible to install the coolers without any modification to the control system there is the possibility to customise the performance using the dip switches contained on the printed circuit board in the control panel.
 |
 |
The default settings and their functions are shown below:
| Switch | Default | Function |
| 1 | Off | Pre Cool Cycle – Allows the pad to wet for 5 minutes before fan starts |
| 2 | Off | Salinity 1 |
| 3 | On | Salinity 2 |
| 4 | On | Salinity 3 |
| 5 | Off | 24 hr dry cycle – Sets the cooler to dry out completely every 24 hrs |
| 6 | Off | Off speed 1390 On max speed 1200 |
| 7 | Off | Off speed 1390 On max speed 1000 |
| 8 | Off | Enables complete stop in Auto instead of remaining at speed 1/vent |
Notes:
The default salinity setting is 30% bleed which is suitable for most mains water supply. Range of 18% to 56% available.
The spare output on the printed circuit board is available to control a ventilation fan which will run whenever the cooler is operational.
The LED will be display the last alarm condition should one have occurred.
